Hi Jim,

I can service the Zenith, if gaskets are not available I can make them.

I may also have a Stromberg with the correct jets for sale if you are interested.

Best wishes,

Neil

Welcome aboard Stuart........I hope the Nipper Grin is soon all over your face! I have always fancied visiting Wales by air, but you seem to be short on airfields! I got my NIpper G-ONCS (Then G-AZBA) from a field near Pembrey Ranges.......had to have a "slot" so I didn't get shot down. Yo...

Hi Malcolm,
Did you get my PM?
Regards
Neil

Hi Richard,
How is the restoration going.....do you have an engine yet?
Regards
Neil

My guess would be a square wave at about 5v.

If you move your engine forward you are going to change the CofG..........

.......I doubt Skycraft would have a clue either....best get out the Oscilloscope and see for yourself?

Gosh,
What are you trying to achieve?
Neil

Hi Malcolm, You say that the oil was black.....after 7 hrs that would suggest overheating of the oil. Does it smell burnt? Do you have oil temp? If so what was it before seizure? Did the engine seize in flight or on the ground? What was the oil temp' before seizure? What was the oil pressure before ...

Bungee mod' approval # is 13004.

Regards

Neil

Rather a poor installation if you need to remove the engine for access. Presumably they have fitted the Leburg units in the box that used to house the magnetos? If so you may be able to remove the fuel tank to access the end of the box which may be removable....or access from the side via the panels...

Hi Malcolm, The fact that the failure has been progressive would suggest that the fault is not down to a supply/earth problem. Can you remove the Leburg Module easily? If so I recommend you remove it, remove the cover and check that the i/c (integrated circuit) has not come out of its holder, or tha...

I am having a clear out and reconciling my needs........I have an 1834cc engine for sale. All parts at new tolerance, it's an engine that I checked over for excessive oil pressure some time ago. I stripped the engine completely, checked and measure all clearances, rebuilt and run on a test bed. It h...

If anyone wants some good "new, old stock" Nieman rings I have a set for sale.
Neil

Hi Malcolm,
PM Sent.
Neil

Rooting through all my Nipper stuff just now I have come up with this: