zenith carburettor 32 KL P 10

[jantar]

This is the carb fitted to the Slingsby Nippers. Anyone out there with expertese, info.,parts supplies, etc.etc. ? Regards Jantar

[Neil Spooner]

Hi,
What do you need?
Neil

[jantar]

Thanks Neill. Have now recieved much tech. info from Anglia Sailplanes but understand that nobody has any parts. Right now I only need a float chamber gasket, but I will try to get one laser cut here ( SA)
Presently awaiting Leburg kit but it has gone astray in the SA mail.

[Neil Spooner]

Ok, pleased you have the info' you need.
There are plenty of carb' specialists in the UK, but if you can't get one then a laser cut on one is nice but sounds expensive, I use a set of cobblers punches that go down to about 1mm dia to make gaskets out of stock material. Is the old one any good as a pattern?
Neil