Anyone using an Aerocarb / AeroInjector / Rotac carb?

Use this forum to discuss technical points relating to the Nipper and its ancilliaries.
MGR
Posts: 31

Anyone using an Aerocarb / AeroInjector / Rotac carb?

Postby MGR » Sun Oct 04, 2026 1:41 pm

Trying to get information about successful installations. Might try to replace my Tillotson if someone has successfully used one of these. Thank a lot.

Neil Spooner
Posts: 635
Location: Ardleigh, Colchester, Essex, UK
Contact:

Re: Anyone using an Aerocarb / AeroInjector / Rotac carb?

Postby Neil Spooner » Thu Oct 22, 2026 7:29 am

I used 3 Rotecs on my RV4, first one the spray bar seals failed, second one was built poorly, third one caused an engine stoppage at 1000’ after takeoff.
They might be better now, but be careful.
I have a v low time Aerocarb for sale if you’re interested. I have not run it.
A little help goes a long way.
Nipper G-BRPM and G-BALS
RV4 G-IKON


Return to “ENGINEERING AND MAINTENANCE”

Who is online

Users browsing this forum: No registered users and 1 guest