Fun level going up :)
-
JimCrawford
- Posts: 149
Re: Fun level going up :)
makes me want to abandon the domestic paperwork and go to the airfield to work on the Nipper!
There seems to be some vertical 'tramping' on the forward looking camera. Is this the mount flexing under G or prop slipstream influence?
Jolly Good Show
Jim
-
svenolivier
- Posts: 83
Re: Fun level going up :)
Hi Jim
Thanks for the comments, you should get into the air with your Nipper
The mount is inflexible so it must be the propwash - i will check the wing camera to see if the "tramping" is something in the airframe - thanks for noticing,
regards
Sven
Thanks for the comments, you should get into the air with your Nipper
The mount is inflexible so it must be the propwash - i will check the wing camera to see if the "tramping" is something in the airframe - thanks for noticing,
regards
Sven
-
Neil Spooner
- Posts: 632
- Location: Ardleigh, Colchester, Essex, UK
- Contact:
Re: Fun level going up :)
Most likely engine vibration. I get the same on Nipper wing and my RV4
Neil
Neil
A little help goes a long way.
Nipper G-BRPM and G-BALS
RV4 G-IKON
Nipper G-BRPM and G-BALS
RV4 G-IKON
-
JimCrawford
- Posts: 149
Re: Fun level going up :)
Smashing video.
Do you mount the camera using the wing tip fixing that holds the tie-down fitting?
Jim
Do you mount the camera using the wing tip fixing that holds the tie-down fitting?
Jim
-
svenolivier
- Posts: 83
Re: Fun level going up :)
Many thanks Jim, the camera is attached with a gopro stickermount, but it has a safety wire connected to the tie-down fitting in case the mount fails (i have lost a camera in the past 
Who is online
Users browsing this forum: No registered users and 0 guests
